Broan 42H-B Appliance Setup, Clean the Appliance, Grate Assembly Placement, Positioning the Logs

Page 16

9 Appliance Setup

A. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated in- side the firebox or underneath in the control cavity.

WARNING

Shock Risk

Fire Risk

Use ONLY optional accessories approved for this appliance.

Using non-listed accessories voids warranty.

Using non-listed accessories may result in a safety hazard.

Only Hearth & Home Technologies approved accessories may be used safely.

B.Grate Assembly Placement

Ensure grate assembly is over burner assembly, centered from left to right, and back legs are in grate brackets (see Figure 9.1)

Back Legs in Grate Brackets

Figure 9.1 Back Legs in Grate Brackets

C. Positioning the Logs

See Section 13.B. for log descriptions and illustrations.

Place right rear log on the grate against the appliance right side wall.

Figure 9.2 Right Rear Log (SRV720)

Place the left rear log on the grate against the left wall and rest it on log.

Figure 9.3 Left Rear Log (SRV728)

Place the fork of log onto the left front bar and rest its back on right rear log.

Figure 9.4 Left Side Log (SRV723)

Place front log in front of the main grate with its left end resting on left rear log as shown.

Figure 9.5 Front Log (SRV727)

16

Heat & Glo LifeStyle Collection • Dakota 42-B/Dakota 42H-B4036-909 Rev D • 08/06

Image 16
Contents This appliance must be installed outside What to do if you smell gasCongratulations Listing Label Information/LocationTable of Contents High Altitude Installations Listing and Code ApprovalsAppliance Certification Glass SpecificationsDesign and Installation Considerations Getting Started¨ Moisture Resistance Tools and Supplies NeededFraming and Clearances Select Appliance LocationFire Risk Fire Risk Odor RiskClearances Mantel ProjectionsTermination Locations Vent Termination Minimum ClearancesRemove Logs and Shipping Cover Appliance PreparationSecuring and Leveling Appliance Gas Information Fuel Conversion Gas ConnectionGas Pressure Fire Risk Explosion RiskFire Risk Explosion Risk Asphyxiation Risk Valve Access Lift Out DoorsRecommendation for Wire Intellifire Ignition System Wiring Connecting to the ApplianceElectrical Information Shock Risk Explosion RiskFinishing FireplaceNoncombustible Facing Diagram Facing MaterialAppliance Setup Clean the ApplianceGrate Assembly Placement Positioning the LogsFront Left Log SRV722 Glass Assembly Placing Lava RockBefore Lighting Appliance Operating InstructionsFire Risk Burn Risk For Your Safety Read Before Lighting Lighting Instructions Lighting the ApplianceFrequently Asked Questions Fire Risk High TemperaturesIssue Solutions After the Appliance is LitSymptom Possible Causes Corrective Actions TroubleshootingIntellifire Ignition System Maintaining and Servicing the Appliance Valve Service and Replacement Tools RequiredGround Wire Maintenance and Service Tasks Inspect Maintenance TasksAppliance Dimension Diagram Reference Materials¨ B. Service Parts List DAKOTA42-B SeriesDescription of Part Replaced by SRV4036-260 Pre Serial #OD9288 Battery Pack 593-594A Also availableSRV727 SRV720 SRV723 SRV722 SRV728 SRV724 SRV742 SRV740 # Description of Part This page intentionally left blank Warranty for Heat & GLO Lifestyle Collection Fireplaces WarrantyDo not Discard this Manual