Vermont Casting EWF30 Installing Outside Air Kit, Installation Precautions, 20008662

Page 11
Installing Outside Air Kit

Nail Top

Standoffs

Nail Side

Nailing

Flanges

Vermont Castings EWF30

of the duct termination and the route of the duct run between the fireplace and the duct termination.

Duct run must be limited to a maximum distance of 40 feet from the fireplace pipe collar to duct termination. This will provide the least restriction to air flow. No more than four (4) 90° elbows can be used. Duct run may be horizontal, vertical, inclined or any combination of these. Vertical duct runs must be at least three (3) feet

FP1565

Fig. 12 Fasten fireplace in position.

Installing Outside Air Kit

An outside air kit may be installed on the EWF30. The AK-MST allows for 100% of required combustion air to come from outside source. If desired, or if local codes mandate the use of an air kit, then an AK-MST is required to complete the installation (from air kit to the outdoors). If the outside air kit is to be used, the

Duct Termination Must be More Than 3’ Below Chimney

Duct Termi- nation

40’ Max.

Duct Run

Attic

Ceiling

Duct

AK-MST MUST be installed BEFORE the fireplace is enclosed.

NOTE: Four (4) inch Class 1 air duct, material or metal duct (not supplied) may be used with AK-MST. (For installation in New York State, only aluminum, non- combustible flexible or type “O” metal ducting is permissible.)

Installation Precautions

The duct termination should be located so it is exposed to an out-of-doors opening at least 100 square inches. If the duct termination must be located in a crawl space or basement, be sure the termination area has 100 square inches of ventilation opening to outside air.

The duct termination must be located so it does not compete for air flow with exhaust fans, gas vent hoods or other air consuming devices or appliances. It must not be obstructed by rafters, insulation materials or other obstructions. The less restrictive the air supply, the better the AK-MST will perform.

It is a good practice to protect your hands and eyes during installation by wearing work gloves and safety glasses.

CAUTION: Do not install termination into a garage or other area that could contain flammable liquids or fumes, or into an attic space.

Installation Instructions

Determine the location of the fireplace as described in the fireplace Installation Manual. Then plan location

Soffit Termination

Exterior Wall

40’ Max. Duct Run

Rain Cap

Duct Termina-

 

tion

Duct

 

 

 

 

Exterior Wall Termination

FP1060

Fig. 13 Typical installations.

below the fireplace chimney flue exit. (Fig. 13) You are now ready to install the AK-MST Outside Air Kit.

1.Remove and discard the outside air cover plate located at the center of the right side of the fireplace. Use care not to rub against the sharp edges of this opening to avoid cuts.

2.Attach the inlet collar with four (4) #10 screws to the side near the bottom of the fireplace. Slide the duct over the collar and attach the duct to the collar using the plastic tie straps or three (3) screws (screws not

20008662

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Do Not Discard This Manual Retain for Future Use EWF30 FireplaceCFM Specialty Home Products Homeowner’s Installation and Operating ManualSave These Instructions for Future Reference Table of ContentsIntroduction Vermont Castings EWF30Drafts Safety InformationPrecautions DescriptionVermont Castings EWF30 SpecificationsEWF30 EWF30 Woodburning Fireplace20008662 Chase InstallationVermont Castings EWF30 Vermont Castings EWF30 30˚ Elbow OffsetsIllustration Key Chimney Requirements - Offset InstallationsThe Ten Foot Rule Planning InformationMounting the Fireplace Planning the Chimney RunInsulating Fireplace Enclosure for Cold Climates InstallationChase Installation Chimney SupportsEB1 Receptacle Hookup Straight-UpChimney InstallationOffset Installation FramingFraming the Ceiling Hole Positioning, Safety Strips Securing the FireplaceCeiling Chimney Hole Possible Obstructions Cutting the HoleVermont Castings EWF30 Installing Outside Air KitInstallation Precautions Installation Instructionsin the Ceiling Hole Installing the Chimney SystemInstalling the Firestop Spacer Proper Firestop Spacer InstallationPenetrating the Roof Continue Installing Pipe to Complete RunCanadian Requirements for Insulation Shield Additional CeilingsFinish Wall Install Remainder of Chimney SectionsInstall Top Housing or Termination Installing Chimney in a ChaseVermont Castings EWF30 Hearth InstallationMantels Side Wall ProtectionEquivalents COMMON MATERIALS AND FACTORSVermont Castings EWF30 Example of Determining Hearth Extension20008662 Minimum Hearth Extension DimensionsVermont Castings EWF30 Minimum Wall ClearancesEWF30 Controls OperationAttach Handles The DamperBurn Only High-QualityWood Use the Air Control SettingsThe Fan Glass DoorsVermont Castings EWF30 Starting and Maintaining a Wood FireReloading and Reviving a Wood Fire Special Tactics for Cold-ClimateHeating20008662 Remove and Store Ash SafelyVermont Castings EWF30 How to Replace Gaskets MaintenanceCleaning the Glass Adjust the Door Latch PeriodicallyReplace Damaged Door Glass Immediately A Clean Chimney System is Safer and Works BetterThe Chimney System Replacing the Door GasketsFireplace Daily Maintenance ScheduleYearly Spring Cleaning Vermont Castings EWF3020008662 Chimney ComponentsVermont Castings EWF30 EWF30 EWF30 FireplaceVermont Castings EWF30 DescriptionEWF30 EWF30 Fireplace continuedVermont Castings EWF30 Ref. DescriptionScreen Kit Optional AccessoriesFan Kit TWABRDescription Trim KitsVermont Castings EWF30 Model20008662 Vermont Castings EWF3020008662 WarrantyLimited 3 Year Warranty CFM Specialty Home Products
Related manuals
Manual 32 pages 45.68 Kb

EWF30 specifications

The Vermont Casting EWF30 is a testament to innovation and craftsmanship in the world of cast iron wood stoves. This highly efficient wood-burning stove combines traditional aesthetics with modern technology, making it a perfect centerpiece for both rustic and contemporary homes. One of the standout features of the EWF30 is its impressive heating capacity. Designed to heat areas up to 2,000 square feet, it is ideal for large spaces, providing consistent warmth during chilly months.

Constructed from high-quality cast iron, the EWF30 offers a durability that only improves with age. This material is known for its excellent heat retention and distribution, resulting in a steady, comfortable warmth. The stove’s classic design includes large ceramic glass windows, allowing users to enjoy the mesmerizing beauty of the fire while safely keeping the warmth inside.

Incorporating advanced technology, the Vermont Casting EWF30 features a clean burning system that significantly reduces emissions. This is a critical aspect for environmentally conscious consumers, as the stove adheres to strict EPA standards, promoting cleaner air and reduced environmental impact. The efficiency of this wood stove is exceptional, with a thermal efficiency rating that maximizes heat output while minimizing fuel usage.

The EWF30 is equipped with a user-friendly air control system, allowing for easy adjustments to the airflow. This system enhances the combustion process, enabling users to achieve the desired flame and heat levels effortlessly. The top-loading design also simplifies the refueling process, making it easier to add wood without disturbing the existing fire.

Aesthetically, the Vermont Casting EWF30 can be customized with various finishes, including traditional black, enamel, and even bold colors, ensuring it fits seamlessly with any interior decor. Additionally, this model includes a removable ash pan, providing a convenient cleaning option.

In summary, the Vermont Casting EWF30 is more than just a wood stove; it is a fusion of tradition and technology. Its heating efficiency, durability, and aesthetic appeal make it a worthy investment for anyone seeking a reliable and stylish heating solution for their home. Whether for ambiance or functionality, the EWF30 is designed to enhance the living experience while respecting the environment.
Top Page Image Contents