Assembly, Step | Kenmore 125.15884801 specification

Leg with Hole

Bolt Holes

Support Tab

Mounting Tab

ASSEMBLY

Choose a level, cleared assembly area and get a friend to help you put your smoker together. Lay cardboard down to protect smoker finish and assembly area.

CAUTION: Some parts may contain sharp edges. Wear protective gloves if necessary.

Note: With the help of a friend, turn the smoker cabinet upside down.

Step 1

Line up holes of leg and cabinet, and attach with M6 X 16 mm bolts; nuts are pre-welded to cabinet. Securely tighten bolts. Attach the leg with hole in the middle of the leg in the position indicated by the arrow in the figure (right front corner). DO NOT yet insert bolts in locations indicated by circles in figure.

Step 2

Place the Control Panel Assembly between the front legs as shown. There are slots on each side of the control panel that fit around the edges of the legs.

Step 3

The two mounting tabs fit to the inside of the legs and line up with the bolt holes. Be sure both the support tabs on the back side of the control panel are captured behind the legs as shown to the right. Insert the two remaining M6 X 16 mm bolts through the mounting tabs and tighten them securely.