Kenmore 415.1612801 manual Ignitor wire, Correctly assembled burner-to-valve engagement

Page 19

Sideburner Valve, Sideburner, Sideburner Bezel, Ignitor Wire, Control Knob

10 Position valve behind fascia and line up holes (A).

Insert (1) of the #8-32x3/8” stainless steel screws, but do not fully tighten.

Slip bezel under inserted screw and position as shown (A).

Line up other hole and insert (1) #8-32x3/8” stainless steel screw through bezel and into valve.

Tighten both securely.

Place sideburner into shelf (B). Make sure to insert valve into sideburner tube. Attach sideburner with (1) wing nut ( C). Under

sideburner shelf, install sideburner clip to sideburner tube and valve. Attach sideburner ignitor wire to electrode as shown (D). Place grate onto sideburner shelf (E).

Press control knob onto sideburner valve stem (F).

Sideburner

Bezel

B

A

C

Wing Nut

Sideburner Valve

Sideburner Valve

D

E

Side
Burner
Tube	Valve
	Valve

Sideburner

Grid

Ignitor wire

		Burner Clip
Correctly assembled burner-to-valve engagement
		Control Knob
	Insert this tip into
#8-32X3/8”	hole in bottom of
#8-32X3/8”	sideburner tube
Stainless Steel Screw	sideburner tube	Clip around
Qty. 2		Clip around
Qty. 2		sideburner
		sideburner
		valve
Wing Nut
Qty. 1

F

464220110 • 19

Image 19

Contents Tools needed for assembly Sears Model No Safety Parts Use and Care AssemblyGrill Information Center Product Record Installation Safety PrecautionsSafety Symbols Call Grill Information Center for Help and PartsWarranty Only LP Tanks equipped with this type of valve LP Tank Valve Safety Cap Retainer StrapLP Liquefied Petroleum Gas LP Tank FillingLP Tank Leak Test Connecting Regulator To The LP TankFor your safety LP Tank ExchangeTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorNever remove threaded orifice at end of valve Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting the Grill SDo not lean over grill while lightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingTurn gas OFF at control knobs and LP cylinder Cleaning the Burner AssemblyStoring Your Grill Very Important Burner tubes must reengage valveIndirect Cooking Instructions Food SafetyHow To Tell If Meat Is Grilled Thoroughly Burner CookingParts List Parts Diagram Bottom Shelf to Legs RearFront Panel Tank Exclusion WireCone side of wheel against leg Wheels and Leg Extenders to Cart20x1/2 screws Grill Head to CartFascia, Right Side Shelf Right Side ShelfSide Burner Shelf Lid removed for clarityLeft Fascia Correctly assembled burner-to-valve engagement Ignitor wireHeat Shield Cooking Grate and Swing Away Heat DiffusersLP Tank Grease Cup Clip, Grease Cup, Grease TrayEmergencies Possible Cause Prevention/Solution TroubleshootingElectronic Ignition Section Troubleshooting Electronic IgnitionPage 464220110 MY-HOME1-800-469-4663 Sears Parts & Repair Service CenterNo matter who made it, no matter who sold it SU-HOGAR