Kenmore 415.1612801 manual LP Liquefied Petroleum Gas, LP Tank Filling, OPD Hand Wheel

Page 4

USE AND CARE

DANGER

NEVER store a spare LP cylinder under or near the appliance or in an enclosed area.

LP Tank

The LP Tank used with your grill must meet the following requirements:

Use LP Tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum.

LP Tanks must be constructed and marked in accordance with specifications for LP Tanks of the U.S. Department of Transportation (DOT) or for Canada, CAN/CSA-B339, tanks, spheres and tubes for transportation of dangerous goods. Transport Canada (TC). See LP Tank collar for marking.

LP Tank valve must have:

Type 1 outlet compatible with

regulator or grill.

Safety relief valve.

UL listed Overfill Protection

Device (OPD). This OPD safety

OPD Hand Wheel

Never fill a cylinder beyond 80% full.

If the information in the two points above is not followed exactly, a fire causing death or serious injury may occur.

An overfilled or improperly stored cylinder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property damage, serious injury or death.

If you see, smell or hear gas escaping, immediately get away from the LP cylinder and appliance and call your fire department.

LP Tank Removal, Transport And Storage

Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only - do not use tools to disconnect. Lift LP tank wire upward off of LP tank collar, then lift LP tank up and off of support bracket. Install safety cap onto LP tank valve. Always use cap and strap supplied with valve.

Failure to use safety cap as directed may result in serious personal injury and/or property damage.

LP Tank Valve

Safety Cap

Retainer Strap

A disconnected LP tank in storage or being transported must have a safety cap installed (as shown). Do not store an LP tank in enclosed spaces such as a carport, garage, porch, covered patio or other building. Never leave an LP tank inside a vehicle which may become overheated by the sun.

Do not store an LP tank in an area where children play.

feature is identified by a unique triangular hand wheel. Use

only LP Tanks equipped with this type of valve.

LP Tank must be arranged for vapor withdrawal and include collar to protect LP Tank valve. Always keep LP Tanks in upright position during use, transit or storage.

LP Tank in upright position for vapor withdrawal

LP (Liquefied Petroleum Gas)

LP gas is nontoxic, odorless and colorless when produced. For Your Safety, LP gas has been given an odor (similar to rotten cabbage) so that it can be smelled.

LP gas is highly flammable and may ignite unexpectedly when mixed with air.

LP Tank Filling

Use only licensed and experienced dealers.

LP dealer must purge new tank before filling.

Dealer should NEVER fill LP Tank more than 80% of LP Tank volume. Volume of propane in tank will vary by temperature.

A frosty regulator indicates gas overfill. Immediately close LP Tank valve and call local LP gas dealer for assistance.

Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.

To remove gas from LP Tank, contact an LP dealer or call a local fire department for assistance. Check the telephone directory under “Gas Companies” for nearest certified LP dealers.

4 • 464220110

Image 4
Contents Tools needed for assembly Sears Model No Safety Parts Use and Care AssemblyGrill Information Center Installation Safety Precautions Safety SymbolsCall Grill Information Center for Help and Parts Product RecordWarranty LP Tank Valve Safety Cap Retainer Strap LP Liquefied Petroleum GasLP Tank Filling Only LP Tanks equipped with this type of valveConnecting Regulator To The LP Tank For your safetyLP Tank Exchange LP Tank Leak TestTurn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorNever remove threaded orifice at end of valve For Safe Use of Your Grill and to Avoid Serious Injury Ignitor Lighting the GrillSDo not lean over grill while lighting Open lid during lightingGeneral Grill Cleaning Sideburner Ignitor LightingSideburner Match Lighting Burner Flame CheckCleaning the Burner Assembly Storing Your GrillVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderFood Safety How To Tell If Meat Is Grilled ThoroughlyBurner Cooking Indirect Cooking InstructionsParts List Parts Diagram Rear Bottom Shelf to LegsTank Exclusion Wire Front PanelWheels and Leg Extenders to Cart Cone side of wheel against legGrill Head to Cart 20x1/2 screwsRight Side Shelf Fascia, Right Side ShelfSide Burner Shelf Lid removed for clarityLeft Fascia Ignitor wire Correctly assembled burner-to-valve engagementHeat Shield Heat Diffusers Cooking Grate and Swing AwayGrease Cup Clip, Grease Cup, Grease Tray LP TankTroubleshooting Emergencies Possible Cause Prevention/SolutionElectronic Ignition Troubleshooting Electronic Ignition SectionPage 464220110 Sears Parts & Repair Service Center No matter who made it, no matter who sold itSU-HOGAR MY-HOME1-800-469-4663