Rock / Stone Application
1.Place the island sections together on the ground.
2.Make sure the ground where the barbecue is place is as level as possible for best alignment.
NOTE: If the ground is not level, use shims to level out the island sec- tions. This needs to be done before you place the bolts.
3.Connect the speak- ers, lights, and main power cables before sliding the sections together.
4.Insert the bolts through the pre- drilled holes from the inside of the barbecue island (to- tal of four bolts on each side). Tighten all bolts using a 9/16” wrench.
5.Prepare mortar in a container.
6.Apply mortar to the gaps left open between the island assembly (front and back).
7.Let it dry for 15 to 30 minutes and brush the area where the mortar mix was applied.
8.Prepare grout in a second container.
2009 Barbecue Islands
7
Installation / Assembly
LTR2009103, Rev. A | www.calspas.com |