Char-Broil 466247310 manual Holes on fascia to

Page 20

10

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

1/4-20x1½”

7mm flat 7mm lock screw washer washer

11 First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Screws and Washers

Note: Use left and right

holes on fascia to

removed from valve bracket

attach valve bracket

Sideburner fascia

Sideburner valve bracket

Install bezel with “OFF” at top.

Note: Use upper and lower

holes on fascia to

attach bezel

 

 

 

 

Control knob

#8-32x3/8” screw

4mm

lock washer

Control knob bezel

Valve stem

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Estimated assembly time 30 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionUSE and Care LP Liquefied Petroleum GasLP Cylinder Filling UL listed Overfill ProtectionLP Cylinder Leak Test For your safetyUseDo not household cleaning agents. Damage to gas Turn all grill control knobs to OFF Leak Testing Valves, Hose and RegulatorConnection, do not use this regulator For Safe Use of Your Grill and to Avoid Serious Injury Main Burner Lighting InstructionsSide Burner Lighting Instructions Sideburner Match LightingBurner Flame Check Ignitor CheckGeneral Grill Cleaning Cooking surfaces If a bristle brush is used to clean anyStoring Your Grill SurfacesCleaning the Burner Assembly Turn gas off at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forKey Qty Description Parts ListNot Pictured Parts Diagram Assembly FrontFixed caster Locking caster Bottom shelf RearGrill head Regulator hose Lower back panel Rear of Shelf Screws and Washers removed from valve bracket Back of main control panel Now you may fully tighten lower screws on upper back panelFront of Shelf Holes on fascia to Sideburner lid Front brace Page Wire Frontbrace Right door Cooking grate Cylinder screw at rear of cart Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionWarranty Registration Department Box Columbus, GA
Top Page Image Contents