Charmglow 720-0289 manual Lighting Instructions, Before LIGHTING…, To Match Light the Grill

LIGHTING INSTRUCTIONS

WARNING: IMPORTANT!

BEFORE LIGHTING…									Approximate
Inspect the gas supply hose prior to turning the gas
									1 1/2“ Flame
“ON”. If there is evidence of cuts, wear, or abrasion, it
									Height
must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be								these conditions exist call our customer service line. If
used. Never substitute regulators for those supplied
								the flame is yellow, it indicates insufficient air. If the
with the grill. If a replacement is necessary, contact
								flame is noisy and tends to lift away from the burner, it
the factory for proper replacement.
								indicates too much air.
Screw the regulator (type QCC1) onto the tank. Leak								TO MATCH LIGHT THE GRILL:
check the hose and regulator connections with a soap
								If the burner will not light after several attempts then
and water solution before operating the grill
								the burner can be match lit.
TO LIGHT THE GRILL BURNER:								If you’ve just attempted to light the burner with the
Make sure all knobs are “OFF” then turn on the gas
								igniter, allow 5 minutes for any accumulated gas to
supply from the LP tank. Always keep your face and
								dissipate. Keep your face and hands as far away from
body as far from the grill as possible when lighting.
								the grill as possible. Insert a lit extended match or
Your grill has an exclusive patented built-in ignition.								lighter through the cooking grids to the burner. Press
								the control knob and rotate left to the HI setting,
The igniter is built		in	to the valve. To ignite				each
								continue to press the knob until the burner ignites.
burner simply push and turn the control knobs to the
								Burner should light immediately. If the burner does not
HI setting, you will hear the valve click as it sends a
								light in 4 seconds turn the knob off, wait 5 minutes
spark to the pilot flame. If the burner does not light,
								and try again.
wait 5 minutes for any excess gas to dissipate and
then retry.								TO LIGHT THE ROTISSERIE BURNER:
Flame Characteristics
								Open the lid; push the knob for about 5 seconds
Check for proper burner flame characteristics. Each
								without rotating. This will allow time for the gas to flow
burner is	adjusted	prior		to	shipment;	however,
								into the rear burner. Continue pushing for 5 seconds
variations	in the local		gas	supply may take			minor
								then turn the knob to the HI position, then press the
adjustments necessary.
								igniter button to light the rotisserie burner. If the
Burner flames should			be blue		and stable with no
								burner does not light, turn the control knob to “OFF”. If
yellow tips, excessive noise, or lifting. If any of
								the igniter does not function, follow the instruction
								above for match lighting.
									Keep a spray bottle of soapy water near the gas
									supply valve and check the connections before
									each use.
									Do not attempt to light the grill if odor of gas is
Visually check the burner flames prior to each use, the									present. Call for service 1-800-913-8999.
flames should look like this picture, if they do not, refer to								17
the burner main tenancies part of this manual									K15Y06P-1