Annual Cleaning of Grill Interior

To ensure a proper working unit the following proper care and maintenance is suggested.

Cleaning Cooking Grids

We suggest you wash your cooking grids in a mild soap and warm water solution. You can use a wash cloth or soft brush to clean your cooking grids.

Cleaning Heat diffusers

Periodically you should wash the heat diffusers in a soap and warm water solution. Use a soft brush to remove stubborn burnt-on cooking residue. The heat diffusers should be dry before you reinstall them.

Cleaning Grease Tray

The grease tray should be emptied and wiped down periodically and washed in a mild detergent and warm water solution. A small amount of sand or cat litter may be placed in bottom of grease tray to absorb the grease. Check the grease tray frequently, don'tallow excess grease to accumulate and overflow out of the grease tray.

Burning-off the grill after every use will keep it ready for your next use. However, once a year you should give the entire grill a thorough cleaning to keep it in top operating condition. Follow these steps.

1.Turn all burner valves to full OFF position.

2.Turn LP gas tank valve to full OFF position.

3.Detach LP gas hose and pressure regulator assembly from your gas grill. Inspect for any damage and replace as necessary with manufacturer replacement part number found on parts list.

4.Remove and clean heat diffusers, cooking grids and grill burners.

5.Cover each gas valve orifice with aluminum foil.

6.Brush inside and bottom of grill with a nylon brush, and wash with a mild soap and warm water solution. Rinse thoroughly and let dry.

7.Remove the aluminum foil, then reinstall heat diffusers, and cooking grids.

8.Reconnect gas source and observe burner flame for correct operation.

Cleaning Exterior Surface

We suggest you wash your grill using a mild soap and warm water solution. You can use a wash cloth or

sponge for this process. Do not use abrasives or a brush that might remove finish during the cleaning process.

Cleaning Exterior Stainless Steel Surfaces

Weathering and extreme heat can cause exterior stainless steel surfaces to turn tan in color. Machine oils used in manufacturing process of stainless steel can also cause this tanning color. Use a stainless steel cleaner to polish stainless steel surfaces of your grill. Never use abrasive cleaners or scrubbers because they will scratch and damage your grill.

Cleaning Exterior Stainless Steel Surfaces

Cleaning Burner Tubes and Burner Ports

To reduce the chance of "FLASH-BACK" the procedure below should be followed at least once a month in late summer or early fall when spiders are most active or when your grill has not been used for a period of time.

1.Turn all burner valves and gas tank valve to off position.

2.Detach the LP gas pressure regulator assembly from your gas grill.

3.Remove cooking grids, heat diffusers, and grease tray from the grill.

4.Remove the screws from the underside of each burner and lift the burners up and away from the gas valve orifice.

5.Using a bent stiff wire in the shape of a hook, air hose or a bottle brush, run it through the burner tube and inside several times to remove any debris.

6.Replace burners, see illustration below.

Step 1. Remove screw which locks ignite wire.

Step 2. Take off R clip which fixes burner at the end side. Step 3. Locate the new burner onto the orifice.

(a)Insert the burner over the main burner gas valve.

(b)Make sure the orifice stud (C1) is inside the burner venture (D1) as shown in (Fig.23).

Step 4. Secure the main burner on the back wall use R clip, and fix on ignite wire.

Fig. 23