Electrolux 34942G operating instructions Seal, Fitting the hob to the worktop

Page 19

Building in

Fitting the hob to the worktop

Before fitting the hob into the cut out, a sealing gasket supplied with the hob must be fitted to the edge of the cut out. It is essential that no gaps are left in this seal in order to prevent spillage near the hob seeping into the cabinet below.

1)Place the sealing gasket all around the edge of the cut out.

2)Place the hob into the cut out and secure it by means of the relevant fixing clamps and screws, as shown in the diagram.

3)Remove the excess seal

FO 0199

Seal

The edge of the hob forms a double seal which prevents the ingress of liquids.

19

Image 19

Contents 34942G During Use Important Safety InformationInstallation Child SafetyEnvironmental Information ServiceContents Guide to Use the instructions Description of the Hob InstallationLighting the burners Using the Wok StandOperation Hob burners control knobsBurners Maintenance and CleaningHob Top Pan SupportsSomething Not Working? Symptom Solution0870 5 929 Service and Spare PartsExclusions Guarantee ConditionsStandard guarantee conditions European GuaranteeEngineers technical data Instructions for the InstallerBurner C a t i o n Important safety requirementsInstallation InstallationGas Connection Building Cut Out SizeBuilding over a cupboard or drawer Building over a kitchen unit with door Fitting the hob to the worktop SealThis HOB Must be Earthed Electrical connectionsPermanent Connection Wiring diagramPreliminary Electrical Systems Check Fault FindingEarth Continuity Check Check gas supply at burner Ignition System / Gas IgnitionCommissioning Pressure TestingMethod Conversion from Natural Gas to LPGPage From the Electrolux Group. The world’s No.1 choice