Aussie pmn owner manual Lighting the Side Burner Elite Series Only

Page 32

Lighting the Side Burner (Elite Series Only)

•Open Side Burner Lid before lighting to prevent an explosion from gas build-up and to prevent burning the paint.

How to light your LP Gas Grill Side Burner (See diagram below for illustrations)

1)Open Side Burner Lid

2)Important: Make sure Side Burner Control Knob is turned “off” first. Make sure the LP gas cylinder valve is open by turning the valve handle counter-clockwise until it stops.

3)From the “Off” position, push in the Side Burner Control Knob (right most knob of the control panel) and turn

counter-clockwise to the “high” position.

4)Push the igniter button several times so that it clicks each time.

5)Check to make sure that the burner is lit.

6)If the side burner does not light, repeat Steps 3 and 4. The burner should light within three or four attempts.

WARNING: If burner fails to light after following Steps 3 & 4, turn Side Burner Knob to the “off” position and close the valve on the LP gas cylinder. Wait five minutes; then repeat all of the above lighting procedures.

Note: If the burner still fails to light, refer to the Troubleshooting page.

2.Make sure Side Burner Control Knob is turned “off” first. Make sure the LP Gas Cylinder valve is open by turning the valve counter-clockwise until it stops.

1. Open Side

Burner Lid.

4. Push igniter

 

 

button to light.

 

 

3. Push the Side Burner Control Knob and

 

 

turn counter-clockwise to the high position.

 

 

 

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents For Your Safety AussieTMImportant Safeguards Page Am 5 pm E.S.T Mon. Fri Telephone Page Elite PART/ DescriptionBushman Part# PART/ Description PART# Cylinder Support/ Retainer Clip Assembly ToolsAttach Legs to Bottom Shelf Attach Wheels to CartTools Attach Rear Support Bar Attach Drip Cup HolderAttach Burner Attach Heat Shield Extend Heat Shield toward left side tank side of BowlMount Igniter/ Flavor Activator Mounting Stud to Grill Bowl Mount Grill bowl to Legs Supplies Needed for a Leak Test How to perform a leak testLeak Test and Attach Control Panel Attach Igniter Wire Attach Control PanelMounting Hood/ Bowl Hinges Mounting Hood Attach Hood Handle Insert Drip CupAttach Side Tables SPACER, Side TableElite Right Side Burner Tools Bushman Elite Models onlyAttach Flavor Activator Insert Cooking Grid Attach LP Cylinder Clip to prevent PinchingLP Cylinder Connecting/ Disconnecting LP Gas Cylinder to GrillGAS, CYLINDER, Hose Regulator Information Selecting a Location Before Using Your LP GAS GrillPrecautions Leak Testing Operating the LP GAS GrillLighting the Grill Using Igniter Preparation Before CookingLighting the Side Burner Elite Series Only Manual Lighting of the Grill Care and Maintenance Burner Maintenance Porcelain coated Cooking Surfaces Deluxe & Elite Series OnlyPreventive Maintenance Cleaning the Grill BowlFlavor Activator Drip CupTroubleshooting Problem Possible Cause SolutionFlare up Important Notice Aussie Grill Company Limited Warranty
Top Page Image Contents