Manual Lighting of the Grill

·Open Hood before lighting the grill to prevent an explosion from gas build-up.

·Always inspect the gas hose and regulator assembly before each use. If the hose is cut, damaged, or showing signs of excessive abrasion or wear, do not use the LP gas grill. Contact the manufacturer, as the hose must be replaced with an assembly specified by the manufacturer prior to further use of the LP gas grill.

How to manually light your LP gas grill

1)Open Hood

2)Important: Make sure Control Knobs are turned “off.” Open the LP gas cylinder valve by turning counter- clockwise until it stops.

3)Insert a lit match through match-lighting hole underneath the grill bowl on the right side. (See figure below).

4)Push in and turn the right main burner control knob counter- clockwise to the “high” position.

WARNING: If the burner fails to ignite after following the above procedure, turn control knob to the off position and close the valve on the LP cylinder. Wait five minutes and repeat all of the above manual lighting procedures. If the grill still fails to light, see the Troubleshooting page.

5)Check to make sure that the burner is lit.

6)Light the remaining half of the burner by turning the control knob counter-clockwise. Your grill has a crossover ignition system that allows the burner to light each side successively.

7)If burner does not light, repeat Step 3. The burner should light within three or four attempts.8) After ignition, preheat the grill by turning the control knobs to “High” for 3- 5 minutes. The grill should be pre-heated before every cooking session. The hood should be closed during preheating.

WARNING: If the burner goes out during the cooking cycle, turn the control knob to the “off” position and close the valve on the LP cylinder. Wait five minutes before attempting to relight.

1. Open hood

2. Turn LP cylinder handle counter-clockwise until it stops.

3.Match lighting hole in right side of grill body - Insert a lit match through the match lighting hole.

4. Push in right con- trol knob and turn counter-clockwise to the “High” position.

NOTE: Shown with right side table removed for clarity.