6.If any of the burners fail to light,repeat Step 4. The burner should light within three or four attempts. If any or all burners fail to light after three or four attempts following Steps
NOTE: If the burner still fails to light, refer to the Troubleshooting Section. The burner can be lit manually, see Manual Lighting of the Grill.
7.After ignition, turn the control knobs to “High” (FIG. 12C) and close the Hood for
FIG. 15A
Control Knob at Resistance Position
FIG. 15B
Control knob in High Position
MANUAL LIGHTING THE GRILL
To reduce the risk of serious bodily injury or death:
·Open Hood before lighting the grill to prevent an explosion from gas
·During failed lighting attempts, or if the burners go out during operation, turn control knobs “Off” to dissipate any accumulation of gas. Wait five minutes before repeating lighting procedure.
·Light each burner from the left before lighting the next burner to prevent gas from accumulating.
1.Open the Hood.
2.Important: Make sure control knobs are turned “Off”.
3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (FIG. 12A)
4.Insert a lit match through one of the match lighting holes underneath the control panel. (FIG. 13)
5.Push in and turn the corresponding burner control knob counter clock wise to the “High” position. (FIG. 12C)
6.Light the remaining burners from left to right by turning the control knob counter clockwise to the High position. Your grill has a crossover ignition system that allows the burners to light successively off one another. Confirm each burner is lit before lighting another.
7.If the burner fails to light, repeat Step 4 & 5. If any or all burners fail to light after three or four attempts following Steps
8.After ignition, turn the control knobs to “High” and close the hood for
Far Right Knob
Far Left Knob
Match Lighting Holes
FIG. 13
FIG.15C 14