Aussie 3 ELITE manual

Page 5

To reduce the risk of injury from handling or lifting: · Assembly may require help from another person.

Step 3) Assemble Bottom Shelf to Legs:

•Place the Leg/Side Table/LegAssemblies opposite each other with the velcro patches on same side. (FIG. 3)

•Place Bottom Shelf upside down inside the Legs. Align the bolt holes of the Bottom Shelf and Legs. Fasten with the 1/4-20 x 1-3/8” bolts, but do not tighten completely. Note: Do not align large hole in bottom shelf with axle holes in legs.

(7)1/4-20 X 1-3/8” Bolt 8 pc

(9) Bottom Shelf

1 pc

(7 ) Bolt, 1/4-20 X 1-3/8”

(9) Bottom Shelf

Note: Do not

Align this Hole

Right Side

Table/Leg Assembly

Left Side Table

Leg/Assembly

FIG. 3

Image 5

Contents LP Gas Grill Assembly and Use Manual Assembly Instructions ContentsSide Table Pcs LeftFront WheelLeg Caster Legs and Side Table AssemblyTowards inside Left Rear 4-20 X 1-3/8Page Page Page Page Page Page Cooking Grid Flame Diffuser Flame Diffuser GuidesUsing GAS CONNECTING/DISCONNECTING the GASLP GAS Cylinder LP Hose and RegulatorOperating and Maintining Your LP GAS Grill Installation CodesSelecting a Location Performing a Leak TestHow to perform a leak test Lighting the Grill Using the Integra Spark Ignition SystemControl Panel Gas Manifold Fittings Hose Fittings Regulator Coupling Nut Connection Regulator SealFar Right Knob Far Left Knob Match Lighting Holes Manual Lighting the GrillGrill Cooking Operating the GAS Grill Check Your Flame Roasting Hood CookingWarming Rack Yellow Tip Primarily BlueEND of Cooking Session Cleaning the GrillHow to Clean the Burners Cleaning the BurnersLift up and slide Burner back Re-assembly of the BurnersGrease fire or exces- sive flames above cooking surface StorageBurner will not light using a match TroubleshootingBurner will not light using the Igniter Or low heat Low flameFlames blow out Flare upService Parts Service Parts Important Notice 03.6098.01 REV