SAFETY INSTRUCTIONS FOR INSTALLATION
Note to the installer:
Please leave this instruction book with the consumer for the local electrical inspector’s use.
The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.
The cabinetry and venting hood should be installed first to prevent damage to the cooktop.
~The countertop must be bonded with heat resistant (212 °F/100 °C) adhesive to prevent distortion or dissolving.
~This appliance has not been designed for maritime use or for use in mobile installations such as recreational vehicles or aircraft. However, under certain conditions it may be possible for installation in these applications. Please contact the Miele Technical Service Department with specific requirements.
~The appliance should not be installed immediately beside an electric barbeque (CS 1312/1322) or the Tepan
Yaki (CS 1326). A minimum distance of 5 7/8" (150 mm) must be maintained between these units.
~Ensure that the power cord will not be subject to mechanical strain after installation.
~Also ensure that the power cord will not come into contact with any hot spots on the appliance after installation. Otherwise, the cable could suffer heat damage.
~Be sure to comply with the clearance distances listed below.
~The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. See "Sealing".
Keep this instruction book in a safe place for refernce and pass it on to any further user.
18