Ignitor Lighting
▲Do not lean over grill while lighting.
1. Turn 
OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.To ignite, push and turn IGNITION BURNER knob to 
HIGH.
5. Push. and hold ELECTRONIC IGNITION button until the burner lights.
6.If ignition does NOT occur in 5 seconds, turn the burner controls
OFF, wait 5 minutes and repeat the lighting procedure.
7.To ignite remaining burners, turn knob to the 
HIGH position starting with the burners closest to IGNITION BURNER first. If ignitor does not work, follow match lighting instructions.
8.For grills equipped with ELECTRONIC IGNITION at each burner:
Repeat steps 4 through 6 to light each burner.
9.Once each burner has ignited, turn knobs to desired setting.
WARNING
Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls 
OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
▲Do not lean over grill while lighting.
1. Open lid. Turn ON gas at LP cylinder.
2.Place match into match holder (hanging from left side panel of grill). Light match; then light burner by placing match through the match light hole on left side of grill.
3.Push in and turn far left burner knob to the 
HIGH position. Be sure burner lights and stays lit.
4.Light adjacent burners in sequence by pushing knobs in and turning to the 
HIGH position.
SEAR Burner Ignitor Lighting
▲Do not lean over grill while lighting.
1. Turn 
OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.To ignite, push and turn SEAR burner knob to 
HIGH.
5. .Push and hold ELECTRONIC IGNITION button until the burner lights.
6.If ignition does NOT occur in 5 seconds, turn the burner
controls 
OFF, wait 5 minutes and repeat the lighting procedure.
SEAR Burner Match-Lighting
▲Do not lean over grill while lighting.
1. Open lid. Turn ON gas at LP cylinder.
2.Place match into match holder (hanging from right side panel of grill). Light match; then light burner by placing match through the match light hole on right side of grill.
3.Push in and turn SEAR burner knob to the 
HIGH position. Be sure burner lights and stays lit.
NOTE: Your grill may NOT be equipped with a Sideburner!
Sideburner Ignitor Lighting
▲Do not lean over grill while lighting.
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Turn sideburner knob to the 
HIGH position, push and hold ELECTRONIC IGNITOR button.
3.If sideburner does NOT light within 5 seconds, turn knob to 
OFF, wait 5 minutes, then
repeat lighting procedure.
Sideburner Match Lighting
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Place lit match near burner.
3. Turn sideburner knob to the
HIGH position.
Be sure burner lights and stays lit.
12