Weber 700 LX owner manual Install Lid, Add tool holders, control panel and burner control knobs

Page 19

Step 19

Install Lid

You will need: lid, two hinge pins and two hair pin cotters.

Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 25.

Hair pin cotter

Hinge pin

Figure 25

Step 20

Add tool holders, control panel and burner control knobs

You will need: two tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail. Figure 26.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 26 (a).

Push on the burner control knobs. Figure 26 (b).

Insert in

frame brace

(a)

Crossover

Ignition Button

Control panel

Phillips screws/

washers

(b)

Tool holders

Figure 26

19

Image 19
Contents Spirit 700 LX Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep REB Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install tank panel assembly and frame connector Install manifold bracketInstall igniter Add fuel scale assemblySet LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingCooking box with finger grip toward you. Figure Install Flavorizer Bars and Cooking GratesInstall the bottom tray Slide the bottom tray onto the mounting rails underAdd tool holders, control panel and burner control knobs Install LidMWARNING The load limit for the swing table is 30 pounds Install swing tableComplete accessory installation To Extinguish LightingManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankRemoval of the LP tank Male fitting Regulator Liquid Propane LP Tanks Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Weber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionPage 15-16 Parts List Final Word Thanks
Related manuals
Manual 36 pages 49.48 Kb