Weber 700 LX owner manual Burner does not light, or flame is low in High position

Page 32

TROUBLESHOOTING

Problem

Check

Cure

 

 

 

Burners burn with a yellow or orange flame, in conjunction with the smell of gas.

Inspect Weber Spider Stopper

Clean Weber Spider Stopper

Guards for possible obstructions.

Guards. (See Section "Annual

(Blockage of holes.)

Maintenance".)

Burners do not light. -or-

Burners have a small flickering flame in the HIGH position. -or-

Barbecue temperature only reaches 250˚ to 300˚ degrees in the HIGH position.

The excess flow safety device, which is part of the barbecue to tank connection, may have activated.

To reset the excess flow safety device turn all burner control knobs and the tank valve OFF. Disconnect the regulator from the tank. Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner control knobs OFF. Reconnect the regulator to the tank. Turn tank valve on slowly. Refer to “Lighting Instructions”.

Burner does not light, or flame is low in HIGH position.

Is LP fuel low or empty?

Refill LP tank.

 

 

Is fuel hose bent or kinked?

Straighten fuel hose.

 

 

Does the Front burner light with a

If you can light the Front burner

match?

with a match, then check the

 

Crossover Ignition System.

Experiencing flare-ups:

Are you preheating barbecue in the

 

prescribed manner?

All burners on high for 10 to 15 minutes for preheating.

Are the cooking grates and

Clean thoroughly. (See Section

Flavorizer Bars heavily coated with

"Periodic Cleaning".)

burned-on grease?

 

mCAUTION: Do not line the bottom tray with aluminum foil.

Is the bottom tray "dirty" and not

Clean bottom tray.

allowing grease to flow into catch

 

pan?

 

Burner flame pattern is erratic. Flame is low Are burners clean?

Clean burners. (See Section

when burner is on HIGH. Flames do not run

"General Maintenance".)

the whole length of the burner tube.

 

 

 

Inside of lid appears to be “peeling.” (Resembles paint peeling.)

The lid is porcelain-on-steel, not

Clean thoroughly. (See Section

paint. It cannot “peel.” What you are

"Periodic Cleaning".)

seeing is baked on grease that has

 

turned to carbon and is flaking off.

 

THIS IS NOT A DEFECT.

 

Fuel scale shows that there is gas in the LP Check adjustment of fuel scale. tank, but tank is empty.

Fuel scale must be adjusted with an empty tank.

If problems cannot be corrected by using these methods, please contact Weber-Stephen Customer Service.

32

Image 32
Contents Spirit 700 LX Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents For Installation in Canada General InstructionsStorage Operating areaStep AssemblyCheck package contents REB Check contents of hardware packs Assemble wheel frame Assemble top frameAdd front panel Continue frame assemblyInstall tubing plugs Add cooking box Install manifold bracket Install tank panel assembly and frame connectorAdd fuel scale assembly Install igniterFill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Check that all burner valves are off Connect LP tankMWARNING Do not ignite burners when leak checking Check for gas leaksInstall Flavorizer Bars and Cooking Grates Install the bottom traySlide the bottom tray onto the mounting rails under Cooking box with finger grip toward you. FigureInstall Lid Add tool holders, control panel and burner control knobsInstall swing table MWARNING The load limit for the swing table is 30 poundsComplete accessory installation Lighting To ExtinguishManual Lighting Periodic Cleaning CookingStorage and/or Nonuse Storage and/or NonuseRemoval of the LP tank Connecting the filled LP tankRefilling the LP tank Male fitting Regulator Safe handling tips for LP Gas Liquid Propane LP TanksMWARNING Do not ignite burners while leak checking Annual MaintenanceInspection and Cleaning of the Weber Spider Stopper Guards General Maintenance Main Burner Cleaning ProcedureMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position MCAUTION Do not line the bottom tray with aluminum foilPage 15-16 Parts List Final Word Thanks
Related manuals
Manual 36 pages 49.48 Kb