Step 5
Measure and drill holes
You will need: Completed frame assembly, base panel, tape measure, and pencil.
CAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.
Note - With the lid open the depth of the barbecue is 28 inches, front to back.
Set the completed frame assembly in position on your deck, concrete pad, or patio for anchoring. Measure the distance from the outside of the base plate to the outside of the other base plate. It should be 26 5/8” across. Figure 3.
Note: If the measurement is not 26 5/8” across adjust the legs as necessary so that the measurement is 26 5/8”.
Step 6
Typical installation of the base for an existing concrete patio, new pad or wood deck
CAUTION: Combustible materials should never be within 24 inches of the top, bottom, back or sides of the barbecue. Do not locate under overhead combustible construction.
Note - With the lid open the depth of the barbecue is 28 inches, front to back.
For anchoring, we recommend use of one of the following methods:
WARNING: Whichever method used, the base must be bolted down (anchored) at a minimum of four anchoring points (two per side) prior to barbecue assembly. One anchor in each corner of the base plate. Figure 5.
25 | 5/8 |
Figure 3
Place the base panel in between the legs to insure fit. Figure 4. Once the fit is established, remove the base panel and mark the holes.
CAUTION: A minimum of 2 bolts are required on each side.
You are now ready to anchor the base.
Figure 4
1
4
2
3
Figure 5
16