Weber Genesis Silver B Gas Grill, 55159 manual Manual Lighting

Page 29

Manual Lighting

DANGER

Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid. Figure 2.

2)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise.)

3)Turn gas supply valve on.

4)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

Manual Lighting

1

2

7

4,6

5

WARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

7)After the FRONT burner is lit you can turn on the other burners.

Note - Always light the FRONT burner first. The other burners ignite from the FRONT burner.

To Extinguish

Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.

Figure 2

WARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

5)Push Front burner control knob down and turn to START/ HI.

6)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.

29

Image 29
Contents Owners Guide Page Customer Service Center Roselle Road, Suite Schaumburg, IL WarrantyContents Gas supply testing Operating area For Installation in CanadaGeneral Instructions StorageGenesis Silver-B Permamount NG Page Page Page Page General Specifications for Piping Typical natural gas supply installation to a wood deck Recommended concrete pad requirements Assemble the frame Continue frame assemblyStep Add Wrap-around Frame Panel Measure and drill holes Method 3 Concrete Method 1 ConcreteMethod 2 Concrete Method 4 Wood deck Add cooking box Check all valves are off Install manifold bracketConnect barbecue gas supply line to the natural gas supply Purge air from gas lines Install igniterCheck for gas leaks BARBECUE. Contact Weber-Stephen Customer ServiceAdd base panel Install side panelsInstall the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidInstall the condiment basket Complete accessory installation Install the accessory rackTo Extinguish LightingManual Lighting Cooking Periodic CleaningAfter a Period of Nonuse Drippings and greaseInspection and cleaning of the Spider/Insect screens Annual MaintenanceMain Burner Cleaning Procedure General MaintenanceWeber Spider/Insect Screen Replacing Main BurnersPage Crossover Ignition System Operations Burner does not light, or flame is low in High position When burner is on HIGH. Flames do not runExperiencing flare-ups Burner flame pattern is erratic. Flame is low