GENERAL INSTRUCTIONS | 23 |
|
|
DANGER
Use of any other hose and regulator assembly could be dangerous, and may not provide adequate gas supply to the Summit®
DANGER
Failure to use the the Summit®
If you do not follow the DANGER statements exactly, the Warranty on the Summit®
LOCATING YOUR LP TANK ENCLOSURE KIT
When determining a suitable location for your LP Tank Enclosure Kit installation, give attention to concerns such as proximity to traffi c paths, and keeping any gas supply lines as short as possible. Never locate the Summit® LP Tank Enclosure Kit in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the LP Tank Enclosure Kit and structure so there is enough room to safely evacuate the area in case of a fi re.
c.
1
b. |
|
| 1 |
|
|
|
|
| 1 |
|
| b. |
|
|
|
|
a.
ENCLOSURE CHART
124˝ inches (610 mm) Any Surface
aLP Tank Enlosure
bAny Surface
c
CLEARANCE FROM COMBUSTIBLE SURFACES OR STRUCTURES
WARNING: Clearance from the outside walls of the sides and back of the LP Tank Enclosure must be a minimum of 24" (60.96cm) any surface. Refer to “Typical Gas Supply Installation” before starting installation.
WARNING: The structure, “island” counter tops and adjacent work areas for the LP Tank Enclosure must be built from noncombustible materials only.
NOTE: If you have questions on what materials are considered noncombustible, contact you local building supplier or fire department.
WWW.WEBER.COM®