9) Reinstall the Spider Stopper Guards. Slightly | Crossover® Ignition System Operations |
rotate the Spider Stopper Guards so that the | If the Crossover Ignition System fails to ignite the Left |
seams are in line with the Venturi fins(1). There | burner, light the Left burner with a match. If the Left |
should be no gaps in the seams or in the fit around | burner lights with a match, then check the Crossover |
the burners(2) and valves(3). | Ignition System. |
| ■ Check that both the white(1) and black(2) ignition |
| wires are attached properly. |
(1)
(3)
(1) | (2) |
(2)
m CAUTION: If the Spider Stopper Guards do not |
|
|
|
| |
|
| |
fit tightly, contact the Customer Service Represen- |
| ■ Check that the Crossover Ignition button pushes the |
| ||
tative in your region using the contact information |
| igniter (button) down, and returns to the up position. |
| ||
sheet provided with your manual. |
| ■ Check to see if the igniter is loose in the frame. |
| ||
m WARNING: After reinstalling the gas lines, they |
| Tighten if necessary; See Step “Install igniter” for |
| ||
should be leak checked with a soap and water |
| correct procedure. |
| ||
solution before using the barbecue. (See Step: |
| If the Crossover Ignition System still fails to light, |
“Check for gas leaks.”) |
| Contact the Customer Service Representative in your |
| ||
|
| region using the contact information sheet provided |
|
| |
|
| with your manual. |
|
|