Weber 500 Series owner manual Continue frame assembly, Install tubing plugs, Add front panel

Page 10

Step 4

Continue frame assembly

You will need: leg frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Place the leg frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside.

Figure 3.

The leg tabs must be on the inside of the frames.

Add the washers to the bolts, insert in the holes as shown and tighten with the wrench. Figure 3.

Dimples to the inside

Figure 3

Step 5

Install tubing plugs

You will need: two tubing plugs and a hammer.

Insert tubing plugs into the ends of the leg frame. Figure 4. To fully seat the plugs, you may have to tap them lightly with a hammer.

Figure 4

Step 6

Add front panel

You will need: front panel and two plastic buttons. Turn frame assembly right side up.

Align the panel with the holes in the frame and insert the plastic buttons through the front panel and frame. Figure 5.

Plastic buttons

View from rear

of barbecue

Figure 5

10

Image 10
Contents Spirit 500 Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents General Instructions For Installation in CanadaGas supply testing StorageCheck package contents AssemblyStep Check contents of hardware packs Assemble wheel frame Assemble top frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install gas supply Install manifold bracketInstall frame connector General Specifications for PipingGas line piping Typical natural gas supply installation. FigureTest connections Install igniter Check that all burner valves are off Connect flexible hose to manifoldCheck for gas leaks MWARNING Do not ignite burners while leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesAllowing grease to flow into the catch pan Install Lid Add tool holders, control panel and burner control knobsComplete accessory installation Lighting To ExtinguishManual Lighting Storage and/or Nonuse Periodic CleaningCooking PreheatingAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsWeber Spider Stopper Guards General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Main Burner Flame PatternTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High Conjunction with the smell of gasPosition Page 11-12 Parts List Page Page Final Word Thanks
Related manuals
Manual 36 pages 58.81 Kb