Weber 475, 675 manual BUILT-IN Sleeve GAS Line Locations

Page 5

BUILT-IN SLEEVE GAS LINE LOCATIONS

Support tubes

Figure 6

BUILT-IN SLEEVE GAS LINE

LOCATIONS

	475	675	Tolerances
A	5.0”	5.0”	+ 1⁄16
			- 1⁄16
B	10.1”	10.1”	+ 1⁄16
			- 1⁄16
C	2.5”	2.5”	+ 1⁄32
			- 1⁄32

The dimensions shown indicate the location of the gas line inlet flange in the insulated sleeve. The support members of the built-in structure must not impede passage of the gas lines.

Area should be kept clear of sharp, jagged, or extremely abrasive surfaces to avoid possible damage to gas supply lines. Exercise caution when pulling gas lines through built-in structure.

Note: Leave an access in the structure for gas supply and regulator service.

5

Image 5

Contents Summit 475 Install GAS Supply Read Carefully Before InstallationLocating Your Barbecue BUILT-IN Construction General InformationBUILT-IN Structure Sleeve Dimensions BUILT-IN Structure Cutout DimensionsBUILT-IN Sleeve GAS Line Locations BUILT-IN Sleeve GAS Line LocationsSupplies Needed Remove Packaged ContentsMount Regulator Bracket ADD Cooking ModuleConnect GAS Supply to Regulator Install Flavorizer BarsADD Cooking Grates Install STEAM-N-CHIPS SmokerInstall Burner Control Knobs Install WARM-UP BasketInstall Bottom Tray Check for GAS Leaks Manifold Reinstall Control Panel Reinstall Front PanelRefer to Operating Guide Before Lighting Barbecue Reinstall Burner Control KnobsInstall Tool Holders