Weber 675, 475 manual Connect GAS Supply to Regulator, Install Flavorizer Bars

Page 8

CONNECT GAS SUPPLY TO REGULATOR

Hard pipe the gas supply to the inlet of the regulator. Refer to “Install Gas Supply” section on page 2.

Connect the corrugated gas line to the regulator. Figure 9. Figure 10 shows the gas line and regulator assembled. Hard pipe the gas supply to the regulator. Figure 11.

Bracket

Regulator

Gas supply to manifold

Figure 9

Bracket

Regulator

Gas supply to manifold

Figure 10

Bracket

Gas supply to manifold

Hard piped

gas supply

Regulator

Figure 11

INSTALL FLAVORIZER BARS

You will need: seven (Summit 475) or eleven (Summit 675) flavorizer bars

Set the Flavorizer bars front to back over the burners in the slots of the Flavorizer Bar/cooking grill support. Figure 12 (a).

To regulator

Summit 475

Figure 12Flavorizer Bar/ cooking grill support

Flavorizer Bar

Slot

To regulator

Summit 675

Figure 12

8

Image 8
Contents Summit 475 Read Carefully Before Installation Install GAS SupplyBUILT-IN Construction General Information Locating Your BarbecueBUILT-IN Structure Cutout Dimensions BUILT-IN Structure Sleeve DimensionsBUILT-IN Sleeve GAS Line Locations BUILT-IN Sleeve GAS Line LocationsRemove Packaged Contents Supplies NeededADD Cooking Module Mount Regulator BracketInstall Flavorizer Bars Connect GAS Supply to RegulatorInstall STEAM-N-CHIPS Smoker ADD Cooking GratesInstall WARM-UP Basket Install Burner Control KnobsInstall Bottom Tray Check for GAS Leaks Manifold Reinstall Front Panel Reinstall Control PanelRefer to Operating Guide Before Lighting Barbecue Reinstall Burner Control KnobsInstall Tool Holders