Brinkmann Series 2630 owner manual Lighting Instructions, Lighting the Main Burners

Page 8

WARNING

LIGHTING INSTRUCTIONS:

Follow the instructions exactly.

1.OPEN THE GRILL LID before attempting to light a burner so that fumes do not accumulate inside the grill. An explosion could occur if grill lid is down.

2.Check that all burner control knobs and the natural gas supply are turned to the OFF position.

3.Turn on the natural gas supply.

4.DO NOT stand with head, body, or arms over the grill when lighting.

LIGHTING THE MAIN BURNERS:

1.Open lid before lighting burner.

2.Make sure all control knobs are in the OFF position.

3.Select the burner to be lit. Push and turn the control knob of that burner to the HIGH position.

4.Press the electronic igniter and hold for 3-5 seconds until burner ignites.

5.If burner does NOT ignite immediately, turn the burner control knob to OFF, wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until burner ignites.

6.If burner does not ignite using the push button igniter wait 5 minutes, see "Match Lighting the Main Burners" section.

7.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position.

MATCH LIGHTING THE MAIN BURNERS:

1. Open lid before lighting.

GRILL LIGHTING INSTRUCTIONS:

 

1.

Read and follow all warnings and instructions

5. Press the electronic igniter and hold for 3-5

7.

Repeat Steps 4-6 for lighting each burner. Always

 

 

 

in owner’s manual before lighting.

seconds to light burner.

 

 

use electronic igniter for lighting each burner.

 

2.

Open lid before lighting burner.

6. If burner does NOT ignite immediately, turn control

8.

Refer to owner’s manual for match lighting procedure.

3.

Make sure all control knobs are in the OFF position.

knob to OFF, wait 5 minutes to allow gas to

9.

For assistance, call 1-800-527-0717.

 

 

4.

Select the burner to be lit. Push and turn the control

dissipate and repeat lighting procedure.

10. To turn off, turn control knobs clockwise until it locks

 

 

 

 

 

 

knob of that burner to HIGH.

 

 

 

in OFF position.

 

 

OFF

OFF

 

OFF

 

OFF

HIGH

HIGH

HIGH

 

 

HIGH

 

 

LOW

LOW

FOR OUTDOOR USE ONLY

LOW

 

LOW

SIDE LIGHT INSTR

1.Fol 1-3

LIG INS

2.Pus

SID con

HIG

3.Fol 5-1

LIG INS

2.Turn the burner control knobs to OFF.

3.Place a paper match in the end of the matchlighter. Strike the match and place through lighting hole in the right hand side of the grill to approximately 1/2" (2 to 3 cm) from the burner.

4.Turn on the FAR RIGHT burner control knob to the HIGH position. The burner should light within 5 seconds.

5.If the burner does not light, turn the control knob to OFF and wait 5 minutes for gas to evacuate the grill. Repeat steps 1 through 5 until the burner ignites.

Lighting Hole

Matchlighter

6.Once lit, light adjacent burners in sequence by pressing in and rotating the control knob to the HIGH position.

7.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and natural gas supply. DO NOT attempt to operate the grill until the problem is found and corrected. See “Trouble Shooting” section of this manual.

7

Image 8
Contents Stainless Steel Outdoor Grill Important Safety For Your SafetyPage Installation Information Connecting Your Grill to the Natural GAS Source Disconnecting Your Grill from the Natural GAS SourceChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Lighting the Side BurnerMatch Lighting the Side Burner Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerCleaning and Maintenance Transporting and StorageBefore Storing Your Grill HardwareBurner ASSEMBLY/MAINTENANCE Cooking GrillsTrouble Shooting Problem Possible Causes Burner will not lightHelpful Hints CleanlinessGrilling to Proper Temperature Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Attach back cart panel by using six M6 X 60mm bolts Hands and fingers Step Side Table Screw Holes Tool Drawer Step Pro Series 2630 Assembled Accessories Gallon PAN & Basket SET Warranty