Rear Leg Receiver
Axle Rod
w" Washer
Axle Cap
Front Legs
Assembled
Rear Legs
Firebox End
Clear an assembly area and get a friend to help you put your smoker together. Lay cardboard down to protect smoker finish and assembly area.
CAUTION: Remember, your new smoker weighs more than 250 lbs. so be extremely careful during the assembly process.
Step 1
With leg screws facing inward, insert axle rod through both rear leg receivers. Place a w" washer on either side of a either 52" or 16" wagon wheel and insert on one end of axle. Repeat on other side. Place axle caps on each end of axle and hammer into place.
Step 2
Place cooker on firebox end with the doors closed as illustrated. Make sure that another person is holding the cooker steady.
Step 3
Install assembled legs onto the leg receivers closest to firebox. Using a 9⁄16" wrench tighten screws securely.
Step 4
Install front legs onto leg receivers with screws facing in. Using a 9⁄16" wrench tighten screws securely.
Step 5
Keeping lids closed and with the help of an assistant, carefully turn the smoker to its upright position. Try to minimize the stress placed on the legs.
CAUTION: Keep lids closed when setting unit upright to prevent bodily injury.
NOTE: Your smoker has been built with a 2" tilt towards the smokestack end. To ensure proper grease drainage always keep your smoker on a level surface.
4