Brinkmann Outdoor Charcoal/Wood Smoker & Grill owner manual Operating Instructions

Page 9

OPERATING INSTRUCTIONS

PLACE THE SMOKER OUTDOORS ON A HARD, LEVEL, NON-COMBUSTIBLE SURFACE

AWAY FROM ROOF OVERHANG OR ANY COMBUSTIBLE MATERIAL. NEVER USE ON WOODEN OR OTHER

SURFACES THAT COULD BURN. PLACE THE SMOKER AWAY FROM OPEN WINDOWS OR DOORS TO PREVENT SMOKE FROM ENTERING YOUR HOUSE. IN WINDY WEATHER, PLACE THE SMOKER IN AN OUTDOOR AREA THAT IS PROTECTED FROM THE WIND.

READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SMOKER.

CAUTION: A metal bucket must be placed under the grease hole at all times to catch grease and/or ashes. Check grease level in bucket often and empty or change when w full. Use extreme caution as bottom of cooking chamber, container and contents will be hot.

Step 1

Place a charcoal grate in firebox. Place cooking grills in cooking.

Step 2

Follow instructions below carefully to build a fire in the firebox. You may use charcoal and/or wood as fuel in the Cimarron (see “Adding Charcoal/Wood During Cooking” section of this manual).

If using a Charcoal Chimney Starter, follow all manufacturer’s warnings and instructions regarding the use of their product. Open the firebox air vent approximately 1" to 2" and smokestack damper halfway. Carefully place 8 to 10 pounds of hot coals in center of charcoal grate in firebox.

WARNING: Keep hot coals away from the firebox air vent to prevent coals from falling out.

IF USING CHARCOAL CHIMNEY STARTER, PROCEED TO STEP 5.

If you choose to use charcoal lighting fluid, ONLY use charcoal lighting fluid approved for lighting charcoal. Do not use gasoline, kerosene, alcohol or other flammable material for lighting charcoal. Follow all manufacturer’s warnings and instructions regarding the use of their product. Place 8 to 10 pounds of charcoal in center of charcoal grate in firebox.

WARNING: Never use charcoal that has been pre-treated with

lighter fluid as a flash fire may occur. Use only a high grade plain charcoal or charcoal/wood mixture.

Step 3

Saturate charcoal with lighting fluid. With lid open, wait 2 to 3 minutes to allow lighting fluid to soak into charcoal. Store charcoal lighting fluid safely away from the smoker.

Step 4

Open the firebox air vent approximately 1" to 2" and smokestack damper half way. With firebox lid open, stand back and carefully light charcoal and allow to burn until covered with a light ash (approximately 20 minutes). Charcoal lighting fluid must be allowed to completely burn off prior to closing firebox lid.

WARNING: Failure to do this could trap fumes from charcoal lighting fluid in smoker and may result in a flash-fire or explosion when lid is opened.

Smoking

8

Image 9
Contents Assembly & Operating Instructions Important Safeguards Properly dispose of all packaging material Parts Bag Contains Assembly InstructionsStep Attach front shelf and side handle to smoker Preparation for USE Lighting Instructions If Using Charcoal Chimney STARTER, Proceed to StepYour Cimarron is NOW Cured Ready for USE Operating Instructions Chamber If Using Charcoal Chimney STARTER, Proceed to Step Placement of Charcoal GrateRegulating Heat Adding Charcoal/Wood in Cooking Chamber Step Adding Charcoal/Wood in Firebox StepProper Care & Maintenance AFTER-USE SafetyAccessories Smoke’N Pit Horizontal Charcoal Grate Cimarron Cooking Grill