Brinkmann 8445 owner manual Connecting Hose and Regulator to AN LP GAS Cylinder

Page 8

WARNING

•Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

WARNING

The pressure regulator and hose assembly supplied with your gas grill must be used.

•DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

•DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. Replacement pressure regulator/hose assembly must be part No 155-8445-S, which can be obtained by contacting customer service at 800-527-0717.

•DO NOT attempt to adjust or repair the regulator. The regulator is designed to operate at a maximum output pressure of 11 inches of water column (2.74 kPa).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your grill. Only the manufacturer's supplied replacement should be used.

WARNING

CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER

•Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and follow all warnings on the LP cylinder.

CONNECTING HOSE AND REGULATOR

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Check that the grill’s burner control knobs are in the "OFF" positions.

3.Remove the protective plastic cap from the cylinder valve and the connection device.

4.Hold regulator and insert the nipple of connection device into the LP cylinder valve outlet. Ensure that the device is centered properly.

5.Turn the large coupling nut clockwise by hand and tighten to a full stop. Take care not to cross thread the coupling nut onto the cylinder valve. Do not over-tighten the knob onto the valve. Do not use tools to tighten connection.

Note: If you are unable to make the connection, repeat Steps 4 and 5.

6.Check that the hose does not contain kinks, does not contact sharp edges, and does not contact surfaces that may become hot during use.

7.Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Heavy-Duty Gas Grill Parrilla de Gas de Alta Resistencia Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Installing the LP GAS Cylinder Onto the Grill Regulator Resetting ProcedureFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Lighting the Side BurnerMatch Lighting the Side Burner Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerHelpful Hints CleanlinessGrilling to Proper Temperature Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCETransporting and Storage Cooking GrillsHeat Distribution Plates Trouble Shooting Before Storing Your GrillFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions Parts ListPage Step Front Back Locking Caster Hex Nut Wrench Spring Pin Door Pivot Hole Alignment Step Without leak testing all Place side burner grate over side burner Step Grease Tray Grease Cup ProSeries 8445 Assembled Importantes Advertencias DE Seguridad PeligroÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Procedimiento DE Reposición DEL Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoManguera Y Regulador Conexión DE LA Manguera Y Regulador Verificación DE Ausencia DE Fugas Pruebas DE Detección DE FugasCuándo Realizar UNA Prueba DE Detección DE Fugas Lista DE Verificación Preliminar AL Encendido Encendido DE LAS Hornillas Principales CON UN Cerillo Instrucciones DE EncendidoEncendido DE LAS Hornillas Principales Apagado DE LA Parrilla Encendido DE LA Hornilla LateralEncendido DE LA Hornilla Lateral CON UN Cerillo Operación DE LA Parrilla Preparación DE LA Parrilla Para Usarla POR Primera VEZPrecalentamiento DE LA Parrilla Control DE LAS LlamaradasCocción Estilo Rotisserie LA Hornilla LateralRecomendaciones Útiles LimpiezaCocinar a LA Parrilla a LA Temperatura Apropiada Limpieza Y Mantenimiento INSTALACIÓN/MANTENIMIENTO DE LAS HornillasContinuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Rejillas Para CocinarPlacas DE Distribución DEL Calor Transporte Y AlmacenajeIdentificación Y Corrección DE Problemas Antes DE Guardar LA ParrillaPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes La bolsa de partes incluirá lo siguienteInstrucciones DE Armado Lista DE PartesPage Paso Delantero Posterior Paso Alinee Hose Heat Shield Ate el escudo contra calor para la Advertencia Rejilla para Calentar Gaveta para Grasa Bandeja para la Grasa ProSeries 8445 Armada Warranty
Top Page Image Contents