Tanita WB-300 Before Use, Level the Scale, Insert the Batteries, Remove the LCD Cover

Page 6

6. Before Use

Level the Scale

For best results, place the scale on a hard, even surface or carpet without padding. If the four feet located on the bottom of the platform do not make full contact with the floor, adjust the height of the two rear feet by hand until the scale becomes stabilized. Note: The two front feet are not adjustable.

Rotate two rear feet clockwise to lower platform and counter clockwise to raise platform.

Insert the Batteries

The scale comes with three (3) replaceable AA alkaline and one lithium battery in a separate bag. The battery compartment is located on the back of the LCD display.

1.Press down and pull battery compartment locking clip to remove the battery compartment cover.

2.Insert batteries with the correct polarity.

3.Replace the battery compartment cover and push it until you hear it click.

Locking Clip

+

CB123A

– OR + CR17335

AA

AA

LITHIUM BATTERY

CB123A OR CR17335

SEE INSTRUCTION MANUAL

+

A A alkaline

AA alkaline

AA

+

A A alkaline

 

 

 

Remove the LCD Cover

Please remove the protection film placed on the LCD before use.

6

Image 6
Contents Table of Contents Electronic Physician ScaleProduct Specifications Important Notes for UsersComponents Description 1900Key Operation Weight LCD Right Side Clock LCD Assembly Instructions List of ComponentsInsert the Batteries Before UseLevel the Scale Remove the LCD CoverSet up the Clock Setting to ZeroAuto-on Function Weighing ProcedureInstructions for Use Turn-on FunctionWake-up Function Measuring Height Procedure WB-300MH and DH Reading the height Measurement Or More General Troubleshooting Weight Capacity ‘E’Resetting the Scale CalibrationReplacing Batteries Tanita Corporation