Panasonic FX-301 manual Fiber

FX-301

PRECAUTIONS FOR PROPER USE

Fiber

Mounting

•The tightening torque must not exceed the values given below.

Mounting with a nut (threaded head type)

	Tightening torque
M3	0.39 N·m
	0.58 N·m		)
M4	350 °C 662 °F heat-resistant fiber and
	FT-H20W-M: 0.98 N m,
	(FD-H35-20S: 0.58 N m
M5	0.98 N·m
	350 °C 662 °F heat-resistant
M6
	(fiber: 1.96 N m	)
M14	1.47 N m

Mounting with a set screw

Tightening torque: 0.29 N m or less

( FT-SFM2L: 0.19 N m )

FT-H20W-M: 0.49 N m

•Fibers for which the tightening section has been specified should be fixed at ?mm from the tightening section tip.

(However, for FT-K8,FT-KV8,FT-WKV8 and FT-V10 ‘?’ ) indicates the range over which tightening cannot be done.

Mounting array fiber

• Using M3 screws, the tightening torque should be 0.58 N m or less.

Mounting FD-L4

• Using M2.6 (length 12 mm 0.472 in) screws with washers (accessor y), the tightening torque should be 0.3 N  m or less.

Mounting FD-WL41 /FD-L41 and FD-WL42 /FD-L42

• Using M3 counter- <FD-WL41 /FD-L41>sunk head screws, the tightening torque should be 0.3 N  m

or less.

		? (mm in)		Tightening torque
	FT-PS1	3 0.118		0.1 N m
	FD-E12	4	0.157	0.29 N m
		(Note 1)
<FT-K8, FT-KV8, FT-WKV8, FT-V10>	FT-V22
	FT-41, FD-V41	10	0.394	0.19 N m
	FT-SFM2SV2
	FD-EG1	10	0.394	0.29 N m
	FT-WV42	15	0.591	0.29 N m
	FD-WV42
	FD-SFM2SV2	7 0.276		0.34 N m
	FT-KV8, FT-WKV8	13	0.512
	FT-V10			0.3 N m
	FT-K8	12	0.472

Notes 1): Excluding the sleeve.

2): When installing, make sure to use screws smaller than the fiber diameter.

<FD-WL42 /FD-L42>

Mounting FD-L43

• Using M3 counter- sunk head screws, the tightening torque should be 0.3 N  m or less.

100 08/2005