BATTERY INSTALLATION/REPLACEMENT
HOW TO APPLY THE ARM CUFF
1.Slide the battery cover off in the direction of the arrow.
2. Install or replace 4 "AA" size batteries so the + (positive) and – (negative) polarities match the polarities of the battery compartment as indicated.
3. Replace the battery cover.
Notes:
If the Low Battery Indicator ( 
) appears on the display, replace all four batteries.
Remove the batteries if the monitor will not be used for an extended period of time.
1.If the cuff is assembled correctly, the hook material will be on the outside of the cuff loop and the metal
2.If the cuff is not assembled, pass the end of the cuff furthest from the tubing through the metal D- ring to form a loop. The smooth cloth should be on the inside of the cuff loop.
3.Sit in a chair with your feet flat on the floor and place your arm on a table so that the cuff is at the same level as your heart.
4.Put your arm through the cuff loop. The bottom of
the cuff should be approximately 1/2" above the elbow. The
Green Marker on the cuff should lie over the brachial artery on the
inside of the arm. Tube should run down center of arm approximately even with middle finger.
AU DEL
O
M
|
|
|
|
| IC |
|
|
|
| L | |
|
|
| O |
| |
|
| T |
|
| |
| S |
|
|
| |
Y |
|
|
|
| |
S |
|
|
|
|
|
LIC |
|
|
TO |
| LSE |
IAS | U | |
D | P |
|
Pile Side Material
Sewn Hook Material
Bottom Edge 1/2 Inch
Cuff Tube
Green Marker
8 | 9 |