Omron Healthcare HEM-629 manual Troubleshooting, Memory Feature Instructions

MEMORY FEATURE INSTRUCTIONS

1. How to store the measured blood pressure values...

The measured and displayed blood pressure and pulse rate readings are automatically stored in the memory.

The memory can store the readings of up to fourteen measurements.

The memory stores the most recent 14 readings. When more than 14 readings have been taken the earliest readings are erased and replaced by the most recent readings. The memory is not erased when the batteries are replaced.

2. How to recall previously measured readings from memory...

While the (♥) symbol is displayed, you can recall and display readings from the memory starting with the previous measured readings.

When you push the MEMORY Button “M”, if there is any measured reading stored in the memory, M1 indicating the latest memory, the systolic and the diastolic blood pressures, and the pulse rate are displayed alternatively.

In order to recall the readings measured previously, push the MEMORY Button “M” again. The values will be displayed as M2, M3,... etc.

If there is no measured reading in the memory, a blank screen with dashed lines will be displayed, when the MEMORY Button “M” is pushed.

3. How to erase the memory...

All the measured readings stored in the memory can be erased simultaneously by operating the buttons as follows:

While the (♥) symbol is displayed, push the MEMORY “M” and the START Buttons simultaneously. Hold both buttons down for at least two seconds, a blank screen with dashed lines will be displayed and the measured readings stored in the memory will be erased.

TROUBLESHOOTING

Error Indicator	Cause	Correction
	Cuff under-inflated	Retake measurement by setting
		cuff inflation level 40 mmHg
		higher than previous level, by
		keep pressing the START
		BUTTON until the cuff
		pressure reaches the
		necessary level.
	Movement during	Be sure not to move and talk
	measurement.	during the measurement.
	No pulse or blood pressure	Wrap the cuff snugly around
		your wrist, carefully read and
	reading due to very weak
		repeat steps listed under “How
	pulse.
		To Apply The Wrist Cuff”
		(page 6).
	Cuff over-inflated (more	Release the START BUTTON
	than 300 mmHg).	before the pressure indication
		reaches 280 mmHg or higher.
		Replace both “AAA” batteries
	Battery voltage is
	excessively low	(See page 5).

NOTES:

-Wait 2-3 minutes before taking another measurement.

-If you continue to have difficulty obtaining a reading, call

OMRON HEALTHCARE CUSTOMER SERVICE TOLL FREE 1-800-634-4350. Please tell the representative

you have an Omron HEM-629 Portable Wrist Blood Pressure Monitor.

10 11