TO SELECT FAN SPEED (5 OPTIONS)
•For AUTO, the indoor fan speed is automatically adjusted according to the operation mode.
TO ADJUST VERTICAL AIRFLOW
DIRECTION (5 OPTIONS)
•Keeps the room ventilated.
•If AUTO is set, the louvers swing up/down automatically.
•In heat mode, the air blows horizontally for a while, then starts to blow downwards.
TO MONITOR AIR QUALITY
•Patrol sensor detects air quality.
•When air quality is unsatisfactory,
TO ENJOY CLEAN AIR
•This operation produces negative ions to attract dust which will then be captured at the positively charged
TO ENJOY QUIET ENVIRONMENT
•This operation reduces indoor and outdoor units noise.
TO ACHIEVE TEMPERATURE
QUICKLY
•This operation will stop automatically after 20 minutes.
•
, 
, 
and 
can be activated in all modes and can be cancelled by pressing the respective button again.
•
and 
or 
and 
can not be activated at the same time.
•
and 
can be activated even when the unit is turned off. In this condition, once
TO SET THE TIMER
• To turn ON or OFF the unit at a preset time.
Select ON or | Set the time. | Confirm. |
OFF timer. |
|
|
|
|
|
•To cancel ON or OFF timer, press 
or 
then
press 
.
•When ON Timer is set, the unit may start earlier (up to 30 minutes) before the actual set time in order to achieve the desired temperature on time.
•Timer operation is based on the clock set in the remote control and repeats daily once set. For clock setting, please refer to Remote Control Preparation at back cover.
•If timer is cancelled manually or due to power failure, you can restore the previous setting (once power is
resumed) by pressing 
.
OPTIONAL SETTINGS
Patrol starts automatically with the unit
switched on with 
.
Press and hold for 5 seconds, then release to disable or restore this setting.
Press and hold for 5 seconds to dim or restore the unit’s indicator brightness.
Press and hold for approximately 10 seconds to show temperature setting in °C or °F.
Press and hold for approximately 5 seconds to show
Press to restore the remote control’s default setting.
,
Not used in normal operations.
Set the temperature 1°C higher in cool mode or 2°C lower in heat mode than the desired temperature to achieve a 10% power saving.
Use curtains to screen off sunlight and outdoor heat to reduce power consumption during cool mode.
5