3Com 3CRWX440095A manual Set igmp lmqi, VLANs on a wireless LAN switch, From 1 through 65,535

360CHAPTER 11: IGMP SNOOPING COMMANDS

set igmp lmqi	Changes the IGMP last member query interval timer on one VLAN or all
	VLANs on a wireless LAN switch.
	Syntax — set igmp lmqi tenth-seconds [vlan vlan-id]
	„	lmqi tenth-seconds— Amount of time (in tenths of a second) that
		the WX waits for a response to a group-specific query after receiving a
		leave message for that group, before removing the receiver that sent
		the leave message from the list of receivers for the group. If there are
		no more receivers for the group, the WX switch also sends a leave
		message for the group to multicast routers. You can specify a value
		from 1 through 65,535.
	„	vlan vlan-id— VLAN name or number. If you do not specify a
		VLAN, the timer change applies to all VLANs.

Defaults — The default last member query interval is 10 tenths of a second (1 second).

Access — Enabled.

History — Introduced in MSS Version 3.0.

Examples — The following command changes the last member query interval on VLAN orange to 5 tenths of a second:

WX1200# set igmp lmqi 5 vlan orange success: change accepted.

See Also

„set igmp oqi on page 363

„set igmp qi on page 364

„set igmp mrouter on page 360

set igmp mrouter Adds or removes a port in a WX’s list of ports on which it forwards traffic to multicast routers. Static multicast ports are immediately added to or removed from the list of router ports and do not age out.

Syntax — set igmp mrouter port port-list{enable disable}

„port port-list— Port list. MSS adds or removes the specified ports in the list of static multicast router ports.