3Com 3CRWX120695A, 3CRWX440095A manual WX1200# set ap 3-4 blink enable success change accepted

set {ap dap} group 267

Examples — The following command enables LED blink mode on the

MAP access points connected to ports 3 and 4:

WX1200# set ap 3-4 blink enable success: change accepted.

set {ap dap} group Configures a named group of MAP access points. MSS automatically load balances sessions among the access points in a group. To balance the sessions, MSS rejects an association request for an access point’s radio if that radio has at least four more active sessions than the radio of the same type with the least number of active sessions within the group.

Syntax — set {ap port-list dap dap-num}group name

„ap port-list— List of MAP access ports to add to the group.

„dap dap-num— Number of a Distributed MAP to add to the group.

„name — MAP access point group name of up to 16 alphanumeric characters, with no spaces.

Defaults — MAP access points are not grouped by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You can assign any subset or all of the MAP access points connected to an WX switch to a group on that switch. All access points in a group must be connected to the same WX switch.

If you use the name none, spelled in any combination of capital or lowercase letters, the specified MAP access point is cleared from all MAP access point groups.

Examples — The following command configures an MAP access point group named loadbalance1 that contains the MAP access points on ports 1, 3, and 5:

WX1200# set ap 1,3,5 group loadbalance1 success: change accepted.