3Com 3CRWX120695A, 3CRWX440095A manual See Also „ clear radio-profileon „ set radio-profile mode on

display {ap dap} config 237

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If the service profile is mapped to a radio profile, you must remove it from the radio profile first. (After disabling all radios that use the radio profile, use the clear radio-profilename service-profilename command.)

Examples — The following commands disable the radios that are using radio profile rp6, remove service-profile svcprof6 from rp6, then clear svcprof6 from the configuration.

WX4400# set radio-profile rp6 mode disable

WX4400# clear radio-profile rp6 service-profile svcprof6 success: change accepted.

WX4400# clear service-profile svcprof6 success: change accepted.

See Also

„clear radio-profileon page 235

„set radio-profile mode on page 291

display {ap dap} Displays global and radio-specific settings for an MAP access point. config

Syntax — display ap config [port-list[radio {1 2}]]

Syntax — display dap config [dap-num[radio {1 2}]]

„port-list— List of ports connected to the MAP access point(s) for which to display configuration settings.

„dap-num— Number of a Distributed MAP for which to display configuration settings.

„radio 1 — Shows configuration information for radio 1.

„radio 2 — Shows configuration information for radio 2. (This option does not apply to single-radio models.)

Defaults — None.

Access — All.

History —Introduced in MSS Version 3.0.