286CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set radio-profile auto-tune power-interval

Sets the interval at which RF Auto-Tuning decides whether to change the power level on radios in a radio profile. At the end of each interval, MSS processes the results of the RF scans performed during the previous interval, and changes radio power levels if needed.

Syntax set radio-profile name auto-tune power-interval seconds

„name — Radio profile name.

„seconds Number of seconds MSS waits before changing radio power levels to adjust to RF changes, if needed. You can specify from 1 to 65535 seconds.

Defaults — The default power tuning interval is 300 seconds.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — RF Auto-Tuning also can temporarily increase a radio’s power level to preserve the minimum data rate for an associated client. In this case, the radio reduces its power in 1 dBm increments until the power returns to the expected level.

Examples — The following command sets the power interval for radios in radio profile rp2 to 240 seconds:

WX4400# set radio-profile rp2 auto-tune power-interval 240 success: change accepted.

See Also

„set {ap dap} radio auto-tunemax-poweron page 270

„set {ap dap} radio auto-tune max- retransmissions on page 271

„set radio-profileauto-tunepower-backoff- timer on page 284

„set radio-profileauto-tunepower-configon page 285

Page 286
Image 286
3Com 3CRWX440095A, 3CRWX120695A manual Set radio-profile auto-tune power-interval