3Com 3CRWX440095A manual Describes the fields in this display, Output for display ap status

248CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 49 describes the fields in this display.

Table 49 Output for display ap status

Field	Description
DAP	Connection ID for the Distributed MAP.
	Note: This field is applicable only if the MAP is configured on
	the WX switch as a Distributed MAP.
Port	WX port number.
	Note: This field is applicable only if the MAP is directly
	connected to the WX switch and the WX switch’s port is
	configured as an MAP access port.
IP-addr	IP address of the MAP. The address is assigned to the MAP
	by a DHCP server.
	Note: This field is applicable only if the MAP is configured on
	the WX switch as a Distributed MAP.
AP model	MAP access point model number.
manufacturer	Company that made the MAP access point.
name	MAP access point name.
Link	Status of this link with the MAP access point and the MAP
	port at the other end of the link. The status can be up or
	down.
MAP port	MAP port number connected to this WX port.
State	State of the MAP:
	„ init — The MAP has been recognized by the WX but has
	not yet begun booting.
	„ booting — The MAP has asked the WX for a boot
	image.
	„ image downloading — The MAP is receiving a boot
	image from the WX.
	„ image downloaded — The MAP has received a boot
	image from the WX and is booting.
	„ configuring — The MAP has booted and is ready to
	receive or is already receiving configuration parameters
	from the WX.
	„ operational — The MAP has received configuration
	parameters for one or more radios and is ready to accept
	client connections.
	„ configure failure — One or more of the radio
	parameters received from the WX is invalid.