3Com 3CRWX440095A Following command enables PoE on ports 4, WX1200# set port poe 4,5 disable

80CHAPTER 4: PORT COMMANDS

Defaults — PoE is disabled on network and wired authentication ports. The state on MAP access point ports depends on whether you enabled or disabled PoE when setting the port type. See set port type ap on page 83.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the WX1200 switch.

Examples — The following command disables PoE on ports 4 and 5, which are connected to an MAP access point:

WX1200# set port poe 4,5 disable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

The following command enables PoE on ports 4 and 5:

WX1200# set port poe 4,5 enable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

See Also

„set port type ap on page 83

„set port type wired-authon page 86

set port preference Configures a gigabit Ethernet port on a WX4400 to use the RJ-45 (copper) interface, when available, as the active link instead of the fiber interface.

Syntax — set port preference port-listrj45

„port-list— List of physical ports. MSS sets the preference on all the specified ports.

„rj45 — Prefers the copper interface.

Defaults — When both the copper and fiber interfaces of a gigabit

Ethernet port are connected, the GBIC (fiber) interface is the active link.

The RJ-45 (copper) link is unused.