3Com 3CRWX120695A, 3CRWX440095A manual Wired Authentication Port Details

set port type wired-auth 87

Syntax — set port type wired-auth port-list[tag tag-list][max-sessions num]

„port-list— List of physical ports.

„tag-list— One or more numbers between 1 and 4094 that subdivide a wired authentication port into virtual ports.

„num — Maximum number of simultaneous user sessions supported.

Defaults — The default tag-list is null (no tag values). The default number of sessions is 1.

Access — Enabled.

History—Introduced in MSS Version 3.0.

Usage — You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. Table 18 lists the default settings that MSS applies when you set a port’s type to ap.

Table 18 Wired Authentication Port Details

Port Parameter	Setting
VLAN membership	Removed from all VLANs. You cannot assign an MAP access
	port to a VLAN. MSS automatically assigns MAP access ports
	to VLANs based on user traffic.
Spanning Tree	Not applicable
Protocol (STP)
802.1X	Uses authentication parameters configured for users.
Port groups	Not applicable
IGMP snooping	Enabled as users are authenticated and join VLANs.
Maximum user	1 (one).
sessions

Examples — The following command sets port 2 for a wired authentication user:

WX1200# set port type wired-auth 2 success: change accepted