238CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Usage — MSS lists information separately for each MAP access point.

Examples — The following example shows configuration information for an MAP access point on WX port 2:

WX1200# display ap config 2

Port 1: AP model: AP2750, POE: enable, bias: high, name: MAP01 boot-download-enable: YES

load balancing group: none

Radio 1: type: 802.11g, mode: enabled, channel: dynamic

tx pwr: dynamic, profile: default

auto-tune max-power: default, min-client-rate: 5.5, max-retransmissions: 10

The following example shows configuration information for a Distributed

MAP access point configured on connection 1:

WX4400# display dap config 1

Dap 1: Serial-Id: M9DE48B012F00, MAP model: AP2750, bias: high, name: DAP1 boot-download-enable: YES

Radio 1: type: 802.11a, mode: disabled, channel: dynamic

tx pwr: 11, profile: default

auto-tune max-power: default, min-client-rate: 24, max-retransmissions: 10

Table 45 describes the fields in this display.

Table 45 Output for display ap config

Field

Description

 

 

Port

WX port number.

 

Note: This field is applicable only if the MAP is directly

 

connected to the WX switch and the WX switch’s port is

 

configured as a MAP access port.

 

 

DAP

Connection ID for the Distributed MAP.

 

Note: This field is applicable only if the MAP is configured on

 

the WX switch as a Distributed MAP.

 

 

Serial-Id

Serial ID of the MAP access point.

 

Note: This field is displayed only for Distributed MAPs.

 

 

AP model

MAP access point model number.

 

 

POE

PoE state on the WX port:

 

„

Enable

 

„

Disable

 

 

 

Page 238
Image 238
3Com 3CRWX440095A, 3CRWX120695A manual Output for display ap config, WX1200# display ap config, WX4400# display dap config