3Com 3CRWX120695A Set ip ssh, „ clear snmp trap receiver on, Secure Shell SSH management traffic

set ip ssh 143

	History — Introduced in MSS Version 3.0.
	Examples — The following command enables the SNMP server on a WX
	switch:
	WX4400# set ip snmp server enable
	success: change accepted.
	See Also —
	„ clear snmp trap receiver on page 114
	„ display snmp configuration on page 128
	„ set port trap on page 82
	„ set snmp community on page 150
	„ set snmp trap on page 151
	„ set snmp trap receiver on page 153
set ip ssh	Changes the TCP port number on which a wireless LAN switch listens for
	Secure Shell (SSH) management traffic.
	CAUTION: If you change the SSH port number from an SSH session, MSS
	immediately ends the session. To open a new management session, you
	must configure the SSH client to use the new TCP port number.

Syntax — set ip ssh port port-num

„port-num— TCP port number.

Defaults — The default SSH port number is 22.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following command changes the SSH port number on a WX switch to 6000:

WX4400# set ip ssh port 6000 success: change accepted.

See Also

„set ip ssh absolute-timeouton page 144