3Com 3CRWX120695A Radios as well as by third-party access points, Syntax display rfdetect data

		display rfdetect data 459
	Table 86 display rfdetect countermeasures Output
	Field	Description
	Rogue MAC	BSSID of the rogue.
	Countermeasures	MAC address of the 3Com radio sending countermeasures
	Radio MAC	against the rogue.
		If the field value is Not Started, MSS has not started
		countermeasures against the rogue yet.
	WX-IPaddr	System IP address of the WX switch that is managing the
		MAP that is sending or will send countermeasures.
	Port/Radio/Channel	Port number, radio number, and channel number of the
		countermeasures radio. For a Distributed MAP, the
		connection number is labeled dap. (This stands for
		distributed ap.)
	See Also
	„ clear rfdetect countermeasures mac on page 456
	„ set rf detect countermeasures on page 465
	„ set rfdetect countermeasures mac on page 466
display rfdetect	Displays all the BSSIDs detected by an individual WX switch during an RF
data	detection scan. The data includes BSSIDs transmitted by other 3Com
	radios as well as by third-party access points.

Syntax — display rfdetect data

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You can enter this command on any WX switch in the Mobility Domain. The output applies only to the switch on which you enter the command. To display all devices that a specific 3Com radio has detected, even if the radio is managed by another WX switch, use the display rfdetect visible command.

To display rogue information for the entire Mobility Domain, use the display rfdetect mobility-domaincommand on the seed switch.