3Com 3CRWX440095A, 3CRWX120695A manual Syntax set radio-profile name

294CHAPTER 9: MANAGED ACCESS POINT COMMANDS

The following command enables the WPA IE on MAP radios in radio profile rp2:

WX4400# set radio-profile rp2 wpa-ie enable success: change accepted.

See Also

„display {ap dap} config on page 237

„display radio-profileon page 257

„set {ap dap} radio mode on page 276

„set {ap dap} radio radio-profileon page 277

set radio-profileChanges the preamble length for which an 802.11b/g MAP radio

preamble-lengthadvertises support. This command does not apply to 802.11a.

Syntax — set radio-profile name

preamble-length {long short}

„name — Radio profile name.

„long — Advertises support for long preambles.

„short — Advertises support for short preambles.

Defaults — The default is short.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — Changing the preamble length value affects only the support advertised by the radio. Regardless of the preamble length setting (short or long), an 802.11b/g radio accepts and can generate 802.11b/g frames with either short or long preambles.

If a client associated with an 802.11b/g radio uses long preambles for unicast traffic, the MAP access point still accepts frames with short preambles but does not transmit frames with short preambles. This change also occurs if the access point overhears a beacon from an 802.11b/g radio on another access point that indicates the radio has clients that require long preambles.