3Com 3CRWX120695A, 3CRWX440095A manual Set igmp qri, VLANs on a WX

set igmp qri 365

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — The query interval is applicable only when the WX is querier for the subnet. For the WX switch to become the querier, the pseudo-querier feature must be enabled on the WX and the WX must have the lowest IP address among all the WX switches eligible to become a querier. To enable the pseudo-querier feature, use the set igmp querier command.

Examples — The following command changes the query interval on

VLAN orange to 100 seconds:

WX1200# set igmp qi 100 vlan orange success: change accepted.

See Also

„ set igmp lmqi on page 360 „ set igmp oqi on page 363 „ set igmp qri on page 365

„ set igmp querier on page 366 „ set igmp mrouter on page 360 „ set igmp rv on page 368

set igmp qri	Changes the IGMP query response interval timer on one VLAN or all
	VLANs on a WX.
	Syntax — set igmp qri tenth-seconds [vlan vlan-id]
	„	qri tenth-seconds— Amount of time (in tenths of a second) that
		the WX waits for a receiver to respond to a group-specific query
		message before removing the receiver from the receiver list for the
		group. You can specify a value from 1 through 65,535.
	„	vlan vlan-id— VLAN name or number. If you do not specify a
		VLAN, the timer change applies to all VLANs.

Defaults — The default query response interval is 100 tenths of a second (10 seconds).

Access — Enabled.