3Com 3CRWX440095A Reset ap dap, WX1200# reset ap, Syntax set ap port-listdap dap-numbias high low

264CHAPTER 9: MANAGED ACCESS POINT COMMANDS

„set service-profile wep active-multicast- index on page 315

„set service-profile wep active-unicast- index on page 316

„set service-profile wep key-indexon page 317

„set service-profilewpa-ieon page 318

reset {ap dap} Restarts an MAP access point.

Syntax — reset {ap port-list dap dap-num}

„ap port-list— List of ports connected to the MAP access points to restart.

„dap dap-num— Number of a Distributed MAP to reset.

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — When you enter this command, the MAP access point drops all sessions and reboots.

CAUTION: Restarting an MAP access point can cause data loss for users who are currently associated with the MAP.

Examples — The following command resets the MAP access point on port 6:

WX1200# reset ap 6

This will reset specified AP devices. Would you like to continue? (y/n)y success: rebooting ap attached to port 6

set {ap dap} bias Changes the bias for a MAP. Bias is the priority of one WX switch over other WX switches for booting and configuring the MAP.

Syntax — set {ap port-listdap dap-num}bias {high low}

„ap port-list— List of ports on which to change the bias for directly connected MAPs.