3Com 3CRWX440095A, 3CRWX120695A „ name Service profile name, Syntax clear service-profile name

236CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Defaults — If you reset an individual parameter, the parameter is returned to the default value listed in Table 57 on page 292.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If you specify a parameter, the setting for the parameter is reset to its default value. The settings of the other parameters are unchanged and the radio profile remains in the configuration. If you do not specify a parameter, the entire radio profile is deleted from the configuration. All radios that use this profile must be disabled before you can delete the profile.

Examples — The following commands disable the radios that are using radio profile rp1 and reset the beaconed-intervalparameter to its default value:

WX4400# set radio-profile rp1 mode disable WX4400# clear radio-profile rp1 beacon-interval success: change accepted.

The following commands disable the radios that are using radio profile rptest and remove the profile:

WX4400# set radio-profile rptest mode disable WX4400# clear radio-profile rptest success: change accepted.

See Also

„display radio-profileon page 257

„set {ap dap} radio radio-profileon page 277

„set radio-profile mode on page 291

clear service-profileRemoves a service profile or resets one of the profile’s parameters to its default value.

Syntax — clear service-profile name

„name — Service profile name.

Defaults — None.