3Com 3CRWX120695A Beacon-interval, Service set identifier Ssid, Specify from 25 ms to 8191 ms

set radio-profile beacon-interval 287

set radio-profile	Changes the rate at which each MAP radio in a radio profile advertises its
beacon-interval	service set identifier (SSID).
	Syntax — set radio-profile name beacon-intervalinterval
	„ name — Radio profile name.
	„ interval — Number of milliseconds (ms) between beacons. You can
	specify from 25 ms to 8191 ms.
	Defaults — The beacon interval for MAP radios is 100 ms by default.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You must disable all radios that are using a radio profile before
	you can change parameters in the profile. Use the set radio-profile
	mode command.
	Examples — The following command changes the beacon interval for
	radio profile rp1 to 200 ms:
	WX4400# set radio-profile rp1 beacon-interval 200
	success: change accepted.

See Also

„display radio-profileon page 257

„set radio-profile mode on page 291

set radio-profileChanges the number of times after every beacon that each MAP radio in

dtim-intervala radio profile sends a delivery traffic indication map (DTIM). An MAP access point sends the multicast and broadcast frames stored in its buffers to clients who request them in response to the DTIM.

The DTIM interval applies to both the beaconed SSID and the nonbeaconed SSID.

Syntax — set radio-profile name dtim-interval interval

„name — Radio profile name.

„interval — Number of times the DTIM is transmitted after every beacon. You can enter a value from 1 through 31.