3Com 3CRWX120695A, 3CRWX440095A manual MAP Access Port Defaults, Stp

set port type ap 85

MAP model MP-262 requires an external antenna for the 802.11b/g radio. You must specify the antenna model. MAP models MP-341 and MP-352 have an internal 802.1b/g antenna as well as a connector for an external antenna, so use of an external antenna is optional on these models. To specify the model, use the set {ap dap} radio antennatype command.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. Table 17 lists the default settings that MSS applies when you set a port’s type to ap.

Table 17 MAP Access Port Defaults

Port Parameter	Setting
VLAN membership	Removed from all VLANs. You cannot assign an MAP
	access port to a VLAN. MSS automatically assigns MAP
	access ports to VLANs based on user traffic.
Spanning Tree Protocol	Not applicable
(STP)
802.1X	Uses authentication parameters configured for users.
Port groups	Not applicable
IGMP snooping	Enabled as users are authenticated and join VLANs.
Maximum user	Not applicable
sessions

This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the WX1200 switch. To manage a MAP access point on a WX4400switch, use the set dap command to configure a Distributed MAP connection on the switch.

Examples — The following command sets ports 1 through 3 and port 5 for MAP access point model AP2750 and enables PoE on the ports:

WX1200# set port type ap 1-3,5 model ap2750 poe enable This may affect the power applied on the configured ports. Would you like to continue? (y/n) [n]y